LOLIN32 Lite手機殼（帶復位按鈕）

Small case for LOLIN32 Lite (ESP32), should snap easily in & out. base-open: pi are reachable at the bottom base-closed: pi at the bottom concealed If you print the cover, lift it off the printing bed carefully - if the cover doesn't fit well (too tee), then file the corner iets a bit (just 0.1 to 0.2mm) so it snaps easier. The two small tunnels iide of the cover guide the LED lights to the cover: Note: your printer must be well calibrated (X/Y as well extrusion flow), otherwise this print won't work for you. Nozzle: 0.4mm Layer height: 0.2mm (or less)