質量效應M-6 Carnifex by Jesshemullet 分割主體

I printed jessthemullet's updated Carnifex which had the main body split into 4 parts with room for italling lights and magnets. However, I wanted to print a veion that had a solid main body. I am printing on the Ender 3 V2, so the main body from his older veion was way too big for my bed. As such, I have split the main body into two and uploaded it here as a remix. UPDATE: I noticed a few of the butto were missing from the originals, so I added them back in. This remix is ONLY the main body. The rest of the parts can be found at either of these: old- updated- I contacted Jess on Itagram and he said that the rest of the parts should be interchangeable. I printed all the other parts from the updated veion, but if I choose to use this solid main body from this remix, then I have to use the trigger from the old veion. I strongly recommend printing this vertically, with the bottom sides (the sides where the handle, trigge, etc. connect) down. Note that Jess's original STLs for the main body were upside-down. I have flipped them to my recommended orientation.